Reverse connection is possible (connection of load side terminal as powerside and power side terminal as load side). How

It is a circuit that maintains "ON" state even when the "ON" command ofthe control coil disappears by using auxiliary co

It is possible to apply if the rated operating current value of a magneticcontator is more than the total rated current

The terminal screw is set in the plastic screw holder and each pole movesone by one. When delivered, the terminal screw

It is not possible to change a contact of SD-Q type.

Cold start operating characteristic is the operating time from flowingcurrents to operating while a heater temparature o

The minimum applicable load is as follows. Contact reliability is indicatedby fault rate λ60 (Number of fault / Operatin

At ambient temperature 40℃, the rated voltage (frequency) is applied to acontrol coil, and after temperature rise and sa

When installing a thermal load relay in the delta phase and detectingphase current, you select a heater designation that

It is utilization category specified in IEC 60947-4-1. AC-1 category is usedfor heater or resistive load etc.

FAQ

FAQAbout Products

Font Size
S
M
L

FAQ > Low-voltage Power Distribution Products > Contactors and Motor Starters

FAQ

Inquiries

Keyword Search

You can search two or more words separated by a space.

 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

Result Type

Text Search

Contactors and Motor Starters

Motor Starters(142)

FAQ within [ Contactors and Motor Starters ]

1-10 of Total 142

prev 1 / 15page next

About Low-voltage Power Distribution Products

Reverse connection is possible (connection of load side terminal as powerside and power side terminal as load side). However, it is necessary toinstall a mag... More Details >>
- No：23286
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

It is a circuit that maintains "ON" state even when the "ON" command ofthe control coil disappears by using auxiliary contact "a" of magneticcontactor itself... More Details >>
- No：23295
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

It is possible to apply if the rated operating current value of a magneticcontator is more than the total rated current of motors. However, athermal load rel... More Details >>
- No：23263
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

The terminal screw is set in the plastic screw holder and each pole movesone by one. When delivered, the terminal screw is set in the screw holder.When tight... More Details >>
- No：23252
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

It is not possible to change a contact of SD-Q type. More Details >>
- No：23341
- Release Date：2018/09/12 15:12
- Category： Motor Starters
About Low-voltage Power Distribution Products

Cold start operating characteristic is the operating time from flowingcurrents to operating while a heater temparature of a thermal load relay isthe same as ... More Details >>
- No：23243
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

The minimum applicable load is as follows. Contact reliability is indicatedby fault rate λ60 (Number of fault / Operating cycles per one contact) atthe relia... More Details >>
- No：23320
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

At ambient temperature 40℃, the rated voltage (frequency) is applied to acontrol coil, and after temperature rise and saturation, it can operatewithout any t... More Details >>
- No：23298
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

When installing a thermal load relay in the delta phase and detectingphase current, you select a heater designation that can be set to 1 / √ 3times of the mo... More Details >>
- No：23240
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

It is utilization category specified in IEC 60947-4-1. AC-1 category is usedfor heater or resistive load etc. More Details >>
- No：23248
- Release Date：2018/09/12 15:11
- Category： Motor Starters

1-10 of Total 142

Inquiries

page top