Wiring of control circuit will be changed depending on whether the maincircuit voltage and control voltage are the same

It is possible to operate it by using two US-N* type. For the interlock ofboth US-N* type, UA-RE type reversible unit is

It is a product that can control two main circuit elements independently,and can be downsized when two or more single-po

The interlock allows only one magnetic starter to be turned"ON" and notanother opposit side magnetic starter in the case

It is necessary to change the wires connected by solder to the board of theDL circuit since the wire length is short. Th

Since a triac element in UT-SY21 type and UN-SY11/21/31 canopen/close, surge voltage does not occur. Therefore, a coil s

It is possible to apply for single-phase circuit. However, it may be lesseffect in single-phase circuit (100 V, etc) sin

The rated impulse withstand voltage of US-H* type is 6KV. This meets therequired impulse characteristic for power distri

SD-T12 to T32 and SD-N600, N800 type operation coil terminals have polarity. Connect terminal mumber A1 (+) to the posi

In the withstand voltage test, 2500V is applied for 1 min. The appliedlocation is as follows.1. Between the conductive p

FAQ

FAQAbout Products

Font Size
S
M
L

FAQ > Low-voltage Power Distribution Products > Contactors and Motor Starters > Motor Starters

FAQ

Inquiries

Keyword Search

You can search two or more words separated by a space.

 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

Result Type

Text Search

FAQ within [ Motor Starters ]

121-130 of Total 142

prev 13 / 15page next

About Low-voltage Power Distribution Products

Wiring of control circuit will be changed depending on whether the maincircuit voltage and control voltage are the same or different. More Details >>
- No：23356
- Release Date：2018/09/12 15:12
About Low-voltage Power Distribution Products

It is possible to operate it by using two US-N* type. For the interlock ofboth US-N* type, UA-RE type reversible unit is used. More Details >>
- No：23375
- Release Date：2018/09/12 15:12
About Low-voltage Power Distribution Products

It is a product that can control two main circuit elements independently,and can be downsized when two or more single-pole type SSCs are used.It is also effe... More Details >>
- No：23376
- Release Date：2018/09/12 15:12
About Low-voltage Power Distribution Products

The interlock allows only one magnetic starter to be turned"ON" and notanother opposit side magnetic starter in the case that two magneticstarters must not b... More Details >>
- No：23244
- Release Date：2018/09/12 15:11
About Low-voltage Power Distribution Products

It is necessary to change the wires connected by solder to the board of theDL circuit since the wire length is short. Therefore, it is not possible toconnect... More Details >>
- No：23299
- Release Date：2018/09/12 15:11
About Low-voltage Power Distribution Products

Since a triac element in UT-SY21 type and UN-SY11/21/31 canopen/close, surge voltage does not occur. Therefore, a coil surgesuppressor is not needed for them. More Details >>
- No：23300
- Release Date：2018/09/12 15:11
About Low-voltage Power Distribution Products

It is possible to apply for single-phase circuit. However, it may be lesseffect in single-phase circuit (100 V, etc) since low voltage circuit is tendedto be... More Details >>
- No：23297
- Release Date：2018/09/12 15:11
About Low-voltage Power Distribution Products

The rated impulse withstand voltage of US-H* type is 6KV. This meets therequired impulse characteristic for power distribution equipment specifiedin IEC stan... More Details >>
- No：23329
- Release Date：2018/09/12 15:11
About Low-voltage Power Distribution Products

SD-T12 to T32 and SD-N600, N800 type operation coil terminals have polarity. Connect terminal mumber A1 (+) to the positive and A2 (-) to the negative sid... More Details >>
- No：23271
- Release Date：2018/09/12 15:11
- Update：2021/04/09 16:21
About Low-voltage Power Distribution Products

In the withstand voltage test, 2500V is applied for 1 min. The appliedlocation is as follows.1. Between the conductive part and the grounded metal part, and ... More Details >>
- No：23305
- Release Date：2018/09/12 15:11

121-130 of Total 142

Inquiries

page top