Since the permanent magnet is used for the electromagnet part of SD-Qtype, it is necessary to match its polarity with th

It is possible to produce with the coil designation of less than AC 230V andDC 220V. Please add " SA" at the end of the

It is the utilization category for opening/closing a heater load ofsemiconductor contactor specified in IEC60947-4-3. Ut

It is not possible to install it on the floor. If doing that, the weight of themoving part of a magnetic starter itself

This is because the delay time becomes shorter since the rebound force ofa spring against the suction force of a magneti

It is possible to apply for single-phase circuit. However, it may be lesseffect in single-phase circuit (100 V, etc) sin

It is a current value that can be closed (turning contact "ON") under theconditions specified in the standards. (In IEC,

A thermal load relay is intended for burnout protection of three-phasesquirrel cage motor. When direct current is applie

It is a contactor that opens/close a main contact part by the force ofelectromagnet (coil).

Each setting knob of the overcurrent trip characteristic is set to the maximum value and then shipped if not specified.

FAQ

FAQAbout Products

Font Size
S
M
L

FAQ > Low-voltage Power Distribution Products

FAQ

Inquiries

Keyword Search

You can search two or more words separated by a space.

 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

Result Type

Text Search

Low-voltage Power Distribution Products

Low-voltage Circuit Breakers(124)

Air Circuit Breakers(23)
Molded Case Circuit Breakers(49)
Earth Leakage Circuit Breakers(21)
Circuit Breakers for Equipment(2)
Circuit Breakers for Use in Particular Applications(6)
Accessories and Related Components(21)
Miniature Circuit Breakers(2)
Contactors and Motor Starters(142)

Motor Starters(142)

Power Management Meters(57)

Electrical Indicators(57)

FAQ within [ Low-voltage Power Distribution Products ]

201-210 of Total 322

prev 21 / 33page next

About Low-voltage Power Distribution Products

Since the permanent magnet is used for the electromagnet part of SD-Qtype, it is necessary to match its polarity with the polarity of the controlcoil. More Details >>
- No：23324
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

It is possible to produce with the coil designation of less than AC 230V andDC 220V. Please add " SA" at the end of the type name. More Details >>
- No：23319
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

It is the utilization category for opening/closing a heater load ofsemiconductor contactor specified in IEC60947-4-3. Utilization categoryAC-51 applies for "... More Details >>
- No：23318
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

It is not possible to install it on the floor. If doing that, the weight of themoving part of a magnetic starter itself acts downward against thetripping spr... More Details >>
- No：23312
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

This is because the delay time becomes shorter since the rebound force ofa spring against the suction force of a magnetic contactor increases if thecontact "... More Details >>
- No：23309
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

It is possible to apply for single-phase circuit. However, it may be lesseffect in single-phase circuit (100 V, etc) since low voltage circuit is tendedto be... More Details >>
- No：23297
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

It is a current value that can be closed (turning contact "ON") under theconditions specified in the standards. (In IEC, number of tests is 50times) More Details >>
- No：23294
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

A thermal load relay is intended for burnout protection of three-phasesquirrel cage motor. When direct current is applied to the thermal loadrelay, the opera... More Details >>
- No：23281
- Release Date：2018/09/12 15:11
- Category： Motor Starters
About Low-voltage Power Distribution Products

It is a contactor that opens/close a main contact part by the force ofelectromagnet (coil). More Details >>
- No：23279
- Release Date：2018/09/12 15:11
- Category： Motor Starters
Default setting of electronic breakers

Each setting knob of the overcurrent trip characteristic is set to the maximum value and then shipped if not specified. However, only the pre-alarm is set to... More Details >>
- No：22438
- Release Date：2018/08/31 14:33
- Category： Molded Case Circuit Breakers

201-210 of Total 322

Inquiries

page top