An object used to change the displayed character string according to the device value

The following objects are available to switch the displayed character string by turning the bit device on or off. 1. Bit comment Use this object to display... More Details >>

I/O numbers and module number of the MELSEC series

These numbers are specified when accessing the buffer memory of the intelligent function module (bus conversion module). The number assignment method differ... More Details >>

When a negative value is displayed on the numerical display instead of a positive value

If a negative value is displayed instead of 40000 when monitoring the device value on the numerical display, check the numerical display settings in the scre... More Details >>

Setting the PLC station number when connecting the GOT to the PLC via Ethernet

The following shows how to set the PLC station number when connecting the GOT to the PLC via Ethernet. Configure the settings in the screen design software.... More Details >>

Port No. in Connected Ethernet Controller Setting when connecting the MELSEC iQ-F series via Ethernet

When connecting the MELSEC iQ-F series (FX5U, FX5UC, FX5UJ, or FX5S) via Ethernet, set Port No. in Connected Ethernet Controller Setting as shown in Table 2.... More Details >>

Operating the objects with the gesture function using the SoftGOT-GOT link function

You cannot operate the objects of the GOT with the gesture function using the SoftGOT-GOT link function, since GT SoftGOT2000 does not support the gesture fu... More Details >>

Open settings for connection to the built-in Ethernet port of the MELSEC iQ-R series

Open settings are required when the communication method of the GOTs is TCP for a single MELSEC iQ-R series controller (built-in Ethernet port). Configure t... More Details >>

How to capture the screen displayed on the GOT

The following methods are available to capture the screen displayed on the GOT. 1. Use the preview function in the screen design software. 2. Select [Proje... More Details >>

Switching the GOT screen from being displayed to hidden

Switching is enabled by using the system information (read device). The GOT screen can be displayed/hidden by turning ON/OFF the Forced Screen Saver Enable ... More Details >>

Ethernet connection between GT SoftGOT2000 and a PLC

The following describes an example of settings to connect GT SoftGOT2000 and the Ethernet port built in the QnUDVCPU by Ethernet. 1. Configure the followi... More Details >>