FAQ
FAQAbout Products
- FAQ > Drive Products > AC Servos-MELSERVO
FAQ
Keyword Search
FAQ within [ AC Servos-MELSERVO ]
-
Is the forced stop signal wiring necessary?
For the safety of use, the wiring is recommended. If not using the wiring, set the parameter No. PA04 to “0100”. More Details >>
- No:23645
- Release Date:2018/09/14 15:10
- Category: MELSERVO-J4
-
You can solder the wiring to the connector without using the junction terminal block (option). More Details >>
- No:23654
- Release Date:2018/09/14 15:10
- Category: MELSERVO-J4
-
Using MR Configurator2, you can perform the positioning operation when there is no command from the controller. You can perform the operation specifying the ... More Details >>
- No:23640
- Release Date:2018/09/14 15:10
- Category: Servo Support Software , MELSERVO-J4 , MELSERVO-JE , MELSERVO-JN , MELSERVO-J3
-
Using MR Configurator2, you can switch the output signals on/off forcibly independently of the servo status. This function is used for output signal wiring c... More Details >>
- No:23639
- Release Date:2018/09/14 15:10
- Category: Servo Support Software , MELSERVO-J4 , MELSERVO-JE , MELSERVO-JN , MELSERVO-J3
-
For the long wiring (50 m to 100 m) between the servo amplifier and servo motor, there are some precautions (encoder cable, etc.) to note. The wiring is not... More Details >>
- No:23632
- Release Date:2018/09/14 15:10
- Category: MELSERVO-J4 , MELSERVO-JE , MELSERVO-JN , MELSERVO-J3 , MELSERVO Others
-
Changing multiplication of analog torque command
Yes, it is. For MR-J4-A/MR-J3-A, set by [Pr. PC13]. As the initial value (100.0%), the maximum torque is generated at ±8 V. To generate the maximum torque a... More Details >>
- No:23628
- Release Date:2018/09/14 15:10
- Category: MELSERVO-J4 , MELSERVO-JE , MELSERVO-J3 , MELSERVO Others
-
“off” is shown in the display.
Operation mode for manufacturer setting is enabled. For MR-J4-B, MR-J4W2-B and MR-J4W3-B, turning "ON (up)" all the control axis setting switches (SW2) enabl... More Details >>
- No:23625
- Release Date:2018/09/14 15:10
- Category: MELSERVO-J4
-
Use the option cable, “MR-J3CN6CBL1M” for the analog monitor of MR-J4-A. More Details >>
- No:23655
- Release Date:2018/09/14 15:10
- Category: MELSERVO-J4
-
Instruction manual of capacity selection software
You can download the instruction manual from the Mitsubishi Electric FA Global Website. Visit the Mitsubishi Electric FA Global Website and go to [Download]... More Details >>
- No:23643
- Release Date:2018/09/14 15:10
- Category: Servo Support Software
-
The module power consumption displays the power consumption of servo motor. Positive value indicates power running and negative value indicates regeneration. More Details >>
- No:23636
- Release Date:2018/09/14 15:10
- Category: Servo Support Software , MELSERVO-J4 , MELSERVO-JE
21-30 of Total 36