The “current command” is the command value for the current control (torque control) and the “torque” is the feedback val

Using MR Configurator2, you can perform the positioning operation when there is no command from the controller. You can

MR-J4-A receives the motor drive command by general pulse train and MR-J4-B does by the optical communication, SSCNET II

Some parameters are write-protected. (MR-J4/MR-J3: PA19)The parameter to be displayed is determined by the setting value

From Start menu of Windows >, click [All Programs] > - [MELSOFT Application] > - [MR Configurator2] > and y

The alarm E7 occurs when the forced stop signal of the servo system controller is enabled. Ensure the safety and cancel

FAQ

FAQAbout Products

Font Size
S
M
L

FAQ > Drive Products > AC Servos-MELSERVO

FAQ

Inquiries

Keyword Search

You can search two or more words separated by a space.

 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

Result Type

Text Search

AC Servos-MELSERVO

FAQ within [ AC Servos-MELSERVO ]

31-36 of Total 36

prev 4 / 4page next

Difference between the current command and torque

The “current command” is the command value for the current control (torque control) and the “torque” is the feedback value controlled by the current control ... More Details >>
- No：23624
- Release Date：2018/09/14 15:10
- Category： MELSERVO-J4 , MELSERVO-JE , MELSERVO-JN , MELSERVO-J3 , MELSERVO Others
Positioning operation

Using MR Configurator2, you can perform the positioning operation when there is no command from the controller. You can perform the operation specifying the ... More Details >>
- No：23640
- Release Date：2018/09/14 15:10
- Category： Servo Support Software , MELSERVO-J4 , MELSERVO-JE , MELSERVO-JN , MELSERVO-J3
Differences between type A and type B

MR-J4-A receives the motor drive command by general pulse train and MR-J4-B does by the optical communication, SSCNET III/H of our motion network. For the de... More Details >>
- No：23648
- Release Date：2018/09/14 15:10
- Category： MELSERVO-J4
Parameter group is not displayed.

Some parameters are write-protected. (MR-J4/MR-J3: PA19)The parameter to be displayed is determined by the setting value of this parameter. Do as follows for... More Details >>
- No：23657
- Release Date：2018/09/14 15:10
- Category： MELSERVO-J3 , MELSERVO-J4
MR-J4(W)-B mode selection application

From Start menu of Windows >, click [All Programs] > - [MELSOFT Application] > - [MR Configurator2] > and you can find “MR-J4(W)-B mode selectio... More Details >>
- No：23637
- Release Date：2018/09/14 15:10
- Category： Servo Support Software , MELSERVO-J4
Alarm E7

The alarm E7 occurs when the forced stop signal of the servo system controller is enabled. Ensure the safety and cancel the forced stop signal of the control... More Details >>
- No：23647
- Release Date：2018/09/14 15:10
- Category： MELSERVO-J4 , MELSERVO-JE

31-36 of Total 36

Inquiries

page top