Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ QD77GF ]

11-20 of Total 31

prev 2 / 4page next

  • Command in-position

    Refer to "b2: Command in-position flag" of "[Md.31] Status". More Details >>

    • No：23598
    • Release Date：2018/09/14 15:09

  • Inching operation

    Set "[Cd.16] Inching movement amount", and turn ON the Forward run JOG start signal or the Reverse run JOG start signal. More Details >>

    • No：23590
    • Release Date：2018/09/14 15:09

  • BUSY signal

    No. The motors' operation is not completely linked to ON/OFF timing of the BUSY signals.BUSY signal is turned ON when the controller starts sending commands ... More Details >>

    • No：23611
    • Release Date：2018/09/14 15:09

  • Error 1201

    Error1201 (HPR data incorrect) occurs when the backup data for absolute position restoration is lost.Execute the machine home position return after checking ... More Details >>

    • No：23604
    • Release Date：2018/09/14 15:09

  • Warning

    No, execute "[Cd.5] Axis error reset" to cancel the error after eliminating the error cause. More Details >>

    • No：23580
    • Release Date：2018/09/14 15:09

  • Torque limit

    Set the torque limit value in "[Cd.101] Torque output setting value" before the positioning start.The values of "[Pr.17] Torque limit setting value" and "[Cd... More Details >>

    • No：23583
    • Release Date：2018/09/14 15:09

  • Speed limit value

    No, there is no impact on the command speed.However, the actual acceleration/deceleration time are affected by the change. More Details >>

    • No：23595
    • Release Date：2018/09/14 15:09

  • Speed change during JOG operation

    Yes. The speed can be changed during JOG operation.Set the new speed with "[Cd.14] New speed value", and then set "[Cd.15] Speed change request" to "1". More Details >>

    • No：23606
    • Release Date：2018/09/14 15:09

  • Positioning start No.

    The following shows the setting value details.• 1 to 600: Positioning data No.• 7000 to 7004: Block start designation• 9001: Machine home position return• 90... More Details >>

    • No：23597
    • Release Date：2018/09/14 15:09

  • Restart

    Set "[Cd.6] Restart command" to "1". More Details >>

    • No：23619
    • Release Date：2018/09/14 15:09

11-20 of Total 31

Inquiries

Contact Us

page top