Retention of auto tuning setting value for temperature control module

Use the automatic backup setting. While "1: enabled" is set in the CH[] automatic backup setting after auto tuning of PID constants in the buffer memory (Un\... More Details >>

Maximum number of modules to be connected to L26CPU-(P)BT

Up to 40 modules. When the branch module and extension module are used, use L26CPU-(P)BT CPU modules whose first 5 digits of the serial number are "13072" or... More Details >>

Using MX Sheet data

If MX Sheet that supports Excel2010 is installed, the data can be used as they are. More Details >>

Duplication error in a CC-Link master station

Possible causes are as follows.(1) Another master station exists on the same line.(2) Noise is detected on the line at power on. More Details >>

Station number settings for MELSECNET/H networks

A station number can be skipped by setting the station as a reserved station. More Details >>

Connecting terminating resistors for CC-Link communication

Connect terminating resistors to both ends of physical cables.A master station is not necessarily required to be connected to either end of its network. More Details >>

Connecting AJ65BT-R2N to a GOT

Yes.When connecting a GOT, set the mode setting switch of AJ65BT-R2N to "5" (MELSOFT connection mode). More Details >>

How to relay CC-Link cables

Use a T-branch repeater module instead of a terminal block. More Details >>

Regarding built-in high-speed counter function

The MX-F Model also supports the built-in high-speed counter function. The number of channels is up to 8, and the counter types supported are 1-phase 1-inpu... More Details >>

Built-in Ethernet function setting window of MELSEC iQ-R series CPU modules

"Module Parameter" of the CPU module is the setting window. <Setting a built-in Ethernet port> [Navigation Window]-> [Parameter]-> [CPU Modul... More Details >>