Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ LD77MS ]

11-20 of Total 32

prev 2 / 4page next

  • Speed limit value

    No, there is no impact on the command speed.However, the actual acceleration/deceleration time are affected by the change. More Details >>

    • No：23595
    • Release Date：2018/09/14 15:09

  • Electronic gear

    Set "[Pr.3] Movement amount per rotation" to "36000000(360.00000degree)", and "[Pr.4] Unit magnification" to "1".The same result is obtained by setting "3600... More Details >>

    • No：23586
    • Release Date：2018/09/14 15:09

  • BUSY signal

    The BUSY signal turns ON even when position control of movement amount "0" is executed.However, since the ON time is short, the ON status may not be detected... More Details >>

    • No：23612
    • Release Date：2018/09/14 15:09

  • Restart

    Set "[Cd.6] Restart command" to "1". More Details >>

    • No：23619
    • Release Date：2018/09/14 15:09

  • JOG speed

    Set "[Cd.17] JOG speed" before starting the operation.When changing the speed during the operation, change it to the new speed with the speed change function. More Details >>

    • No：23581
    • Release Date：2018/09/14 15:09

  • Error 1205

    Error 1205 (SSCNET communication error) occurs when erroneous data is received from servo amplifier. [When the servo parameter "[PA14] Rotation direction se... More Details >>

    • No：23614
    • Release Date：2018/09/14 15:09

  • Positioning start No.

    The following shows the setting value details.• 1 to 600: Positioning data No.• 7000 to 7004: Block start designation• 9001: Machine home position return• 90... More Details >>

    • No：23597
    • Release Date：2018/09/14 15:09

  • Servo motor rotation direction

    To reflect the change, set "[PA14] Rotation direction selection/travel direction selection" and cycle the servo amplifier or execute a home position return a... More Details >>

    • No：23620
    • Release Date：2018/09/14 15:09

  • Current value change

    The following shows the procedure for changing the current value to a new value.(1) Write the new current value to "[Cd. 9] New current value".(2) Write "900... More Details >>

    • No：23585
    • Release Date：2018/09/14 15:09

  • Axis error reset

    It depends on the servo error.Some can be cleared by "[Cd.5] Axis error reset" but the other cannot unless the servo amplifier's power is turned OFF.Refer to... More Details >>

    • No：23584
    • Release Date：2018/09/14 15:09

11-20 of Total 32

Inquiries

Contact Us

page top