Communication between the Ethernet po...

The communication can be established using the following methods. - Using the socket communication function of both CPU modules - Using the simple PLC comm... More Details >>

Recommended cables for the MODBUS(R) ...

For 100BASE-TX, shielded twisted pair cables (STP cables) with category 5 can be used.For 10BASE-T, Straight and unshielded twisted pair cables (UTP cables) ... More Details >>

Ladder programs for GX Configurator-FL

When GX Configurator-FL is used, programs for initial settings and cyclic data reading and writing are not needed. More Details >>

Replacing Q02CPU with Q02H

Yes. More Details >>

MODBUS(R) interface module's involvem...

Intelligent function module settings allow them to be set in both master and slave stations. More Details >>

Simulation function not started

The simulation function utilizes the standard TCP/IP communication provided by Microsoft Corporation. A communication capability of software of another make... More Details >>

The VxWorks simulator CW-SIM

CW-SIM is a simulation software that allows a VxWorks program to be executed on a personal computer without a C Controller module. There are two types of CW... More Details >>

Label programs in GX Works2

Change the program using the following method.Write the label program to the programmable controller CPU and perform PLC read for the parameters and the prog... More Details >>

Boot operation from the standard ROM ...

The universal model QCPU modules have their standard ROM but boot operation from the standard ROM is impossible. Boot the module from a memory card. More Details >>

Socket communication with the built-i...

The communication between programmable controllers can be established using the socket communication function instructions. More Details >>