Difference between FL-net interface m...

- QJ71FL71-T is a product which supports FL-net (OPCN-2) Version 1.00.- QJ71FL71-T-F01 is a product which supports FL-net (OPCN-2) Version 2.00.Since Version... More Details >>

Specification method of high-speed timer

To use a high-speed timer, insert a circuit of application instruction such as "OUTH T0 K100". More Details >>

Turning OFF the power with the batter...

It deletes the error history. More Details >>

Difference between C Controller modul...

- C Controller module: Programs are created using C and C++ languages. The programs run based on each task and parallel processing of multiple tasks base... More Details >>

Device comment

Those displayed under COMMENT are common comments, and others are program comments.When there are multiple programs in a project, a common comment applies to... More Details >>

GX Simulator in GX Works2 disk

The simulation function is included in GX Works2.For more details of the functions of GX Work2, refer to GX Works2 Version 1 Operating Manual (Common). More Details >>

Duplicated coil error

The duplicated coil error is detected when SET instruction and RST instruction use the same device. More Details >>

GX Developer installation procedure f...

Use setup.exe in the [GXD1] folder of the installation disk to install the application. More Details >>

CPU modules supporting the serial com...

CPU modules supporting the serial communication function are as follows. - Q00UJCPU,Q00UCPU,Q01UCPU - Q02UCPU 10102 or later (with GX Works2 1.15R or l... More Details >>

High-speed timer

Follow the procedure below to insert a high-speed timer.- Click the Coil button on the toolbar or press the function key F7, then enter "HT[ ] K[ ]".- Click ... More Details >>