CC-Link signals checked when an error occurs

Check the following signals.- Module error signal : X0- Host data link status signal: X1- Other station data link status signal: X3 More Details >>

How to check link errors in CC-Link slave stations

The data link status is stored in SW80 to SW83.Each bit corresponds to a station number and a bit turns ON if the corresponding station causes a data link er... More Details >>

Whether or not multiple QJ72LP25-25 modules can be mounted

No, only a single QJ72LP25-25 can be mounted (and is to be mounted on the CPU slot on a main base unit). More Details >>

Applicable size for plug-in connector socket block on QJ71C24N-R4

Use the plate terminal packaged with the module. The size of the plate terminal is 1.0 mm wide with a thickness of 0.8 mm. More Details >>

Unit of receive data used by the QJ71C24N series pre-defined protocol support function

The fixed data is used for specific codes and character strings such as a command. Setting a device is not required. More Details >>

Continuous executions of protocols by the QJ71C24N series CPRTCL instruction

One CPRTCL instruction can execute a maximum of eight protocols. More Details >>

Model name of the connector used for the FCN connector type CC-Link remote I/O module

FCN connectors (40-pin connector) are shown below.- A6CON1 (soldering connector)- A6CON2 (crimp connector)- A6CON3 (pressure-displacement connector)- A6CON4 ... More Details >>

Refresh timing of bit data and word data in the same CC-Link station

Cyclic data is sometimes separated into new and old data by two words (32 bits) with auto refresh timing. Checking "Block data assurance per station" of the ... More Details >>

Grounding of CC-Link

The functional grounding is applied to ensure the reliability of the communication. More Details >>

Terminating resistors for RS-422 communication of QJ71C24N

The resistance value is 330 ohm, 1/4 W. More Details >>