Support of the DHCP (Dynamic Host Configuration Protocol) function by the FX3U-ENET-L (for Ethernet communications)

The FX3U-ENET-L does not support the DHCP function. Set the fixed IP address using FX Configurator-EN-L. (FX Configurator-EN-L can be downloaded from Mitsubi... More Details >>

MELSOFT MT Works2

MELSOFT MT Works2 is engineering software for Motion controllers that provides comprehensive support - from system design, parameter settings, program creati... More Details >>

RS-485 connection between LJ71C24 and an external device

Short between SDA and RDA and between SDB and RDB, and then connect them to + (Data-A) and - (Data-B) on the external device. More Details >>

Overall cable distance and station-to-station distance in CC-Link networks

The overall cable distance and station-to-station distance depend on the version and the transmission speed. Figure 1 shows the case with Ver.1.10-compatibl... More Details >>

Read and write operations for CC-Link buffer memory

There is no problem in writing/reading data into/from the buffer memory using a FROM/TO instruction with the refresh device setting left blank.The refresh de... More Details >>

Writing comments into a programmable controller

Make a space for comments in the parameter setting of the programmable controller with GX Developer.To write the created comments into a programmable control... More Details >>

MX Component Version 4's compatibility with Visual Studio 2005

Yes. More Details >>

Number of records in LCPU logging function

It is the number of data collected before and after a trigger occurrence. More Details >>

Open setting of the built-in Ethernet port QCPU

No.It is necessary to configure one port to use the MELSOFT connection. More Details >>

QnA-compatible 3E frame command (0406) for the built-in Ethernet port QCPU

The built-in Ethernet port QCPU is not compatible with a multiple-block batch read command (0406) of the MC protocol. Executable commands are the following.... More Details >>