Boot file setting of the QnUDVCPU

No. You cannot use an SRAM card, ATA card, or Flash card. Specify an SD memory card as the transfer source (boot source). More Details >>

Measuring temperatures with programmable controllers

The following four models are available for the purpose.- Q64TD- Q64TDV-GH- Q68TD-G-H01- Q68TD-G-H02 More Details >>

Heat generation of Q61P power supply module

Since the conversion efficiency of the power supply module is approximately 70%, and 30% of the output power is dissipated as heat, the power consumption is ... More Details >>

Accessories of the MELSEC iQ-R series 40-pin connector type module

No connector is provided with the module. Separately prepare any of the following connectors. A6CON1: Soldering type 32-point connector (40-pin connector) A6... More Details >>

Extending the extension cable

It is not possible to extend the length of the extension cable to over 65cm. Place the main unit separately by using the parallel link or N:N Network functio... More Details >>

Unit of receive data used by the QJ71C24N series pre-defined protocol support function

The fixed data is used for specific codes and character strings such as a command. Setting a device is not required. More Details >>

Assigning X and Y signals of AJ65SBTB1-32DT

X and Y assignments are as follows.- X0 to XF- Y10 to Y1F More Details >>

Communication between a CC-Link master station and local stations

There are two modes of transient transmission, cyclic transmission and transient transmission, for the communication between a master station and a local sta... More Details >>

Detecting the number of disconnections when using QJ71E71-100

The number of disconnections detected can be checked by reading the buffer memory address 5203H (Disconnection detection count). Disconnections are detected ... More Details >>

Connecting terminating resistors to the sending end and the receiving end in communication of QJ71C24N

Yes. More Details >>