Duplicated coil error

The duplicated coil error is detected when SET instruction and RST instruction use the same device. More Details >>

Capacity setting of file registers

Set 96K points. (1K point = 1024 points) More Details >>

How to write comments of GX Works2 into the standard ROM

Switch the Target Memory to "Standard ROM" in the "Write to PLC" window. More Details >>

Compatibility between the A series modules and Q series modules

When an ACPU module is replaced with a QCPU module, programs for the ACPU module can be used by changing the PLC type in GX Developer. However, the programs ... More Details >>

MC protocol response messages

There are no settings for deleting the network number and PC number. More Details >>

Pulse width with which the QX42 recognizes all pulses

Maximum scan time (10 ms) + Response time (10 ms) = Pulse width with which the module recognizes all pulses (20 ms) More Details >>

Number of points used for I/O assignment of LCPU built-in I/O function

X00 to X0F and Y00 to Y07 are sorted for each function. For more details, refer to "MELSEC-L CPU Module User's Manual (Built-In I/O Function)". More Details >>

How to increase file register capacity

In LCPU, file register capacity depends on CPU. The number of file register points cannot be increased. (A file register cannot be set on an SD memory card.)... More Details >>

Compliance with SEMI-F47 for L series power supply module

Use the following power supply module with an input power of 200 VAC for compliance with SEMI-F47. - Power supply module: L61PWith an input power of 100 VAC,... More Details >>

Conversion speed of L60AD4

The conversion speed is as follows. - High speed: 20 microseconds per channel- Medium speed: 80 microseconds per channel- Low speed: 1 millisecond per channel More Details >>