Whether or not MC protocol frames can be used after A1SJ71UC24 is replaced with QJ71C24N

The QJ71C24N series modules can be accessed using A-compatible 1C frames, but the following restrictions are imposed. The access is limited to the devices wi... More Details >>

Difference between AJ65SBTB1-16DT1 and AJ65SBTB1-16DT2

Major differences are shown below. - AJ65SBTB1-16DT1 - Rated input current approx. 5 mA - ON voltage/ON current 15 VDC or higher/3.0 mA or higher - O... More Details >>

Terminating resistors for RS-485 communication of LJ71C24

The resistance value is 110 ohm, 1/2 W. More Details >>

MODE switch setting for QJ61BT11N

The MODE switch can set the following modes.- 0 to 4: Online mode- 5 to 9: Line test mode- A to E: Hardware test modeEach mode in ascending order of set valu... More Details >>

Assigning X and Y signals of AJ65SBTB1-32DT

X and Y assignments are as follows.- X0 to XF- Y10 to Y1F More Details >>

Unit of the receive data length used by the QJ71C24N series pre-defined protocol support function

The receive data length of the variable is specified in bytes. More Details >>

Terminal blocks for the MELSEC-F series

Whether the terminal block is removable or not differs depending on the series. Types of the terminal blocks for the MELSEC-F series main units are as follow... More Details >>

Parameter setting of FX3U-1PG

Whether the positioning parameter is used or the extension positioning parameter is used can be selected in BFM#32 (positioning parameter selection). Select ... More Details >>

Connection of expansion boards and a memory cassette to the FX3G series main unit

They can be used together. * 14/24-point type FX3G series main unit ･ An expansion board can be connected to BD1 (1st position) and a memory cassette can b... More Details >>

Switching network between 10BASE-T and 100BASE-TX of the FX3U-ENET-L

It cannot be freely switched. It is automatically switched according to the auto detection function. More Details >>