Pulse output system of the FX3U-1PG pulse output block

Forward (FP) and reverse (RP) pulse or pulse (PLS) with direction (DIR) can be selected. More Details >>

Maximum length of input wiring

Although it depends on the operating environment, wiring within 20 m is generally recommended. More Details >>

Gratis warranty term of the FX programmable controllers

The longest gratis warranty term after manufacturing shall be eighteen (18) months. For details, refer to the gratis warranty term explained in the applicabl... More Details >>

Support of the DHCP (Dynamic Host Configuration Protocol) function by the FX3U-ENET-L (for Ethernet communications)

The FX3U-ENET-L does not support the DHCP function. Set the fixed IP address using FX Configurator-EN-L. (FX Configurator-EN-L can be downloaded from Mitsubi... More Details >>

CD terminal setting of the QJ71C24N

"The CD terminal is not checked" has been set by default. More Details >>

Applicable size for plug-in connector socket block on QJ71C24N-R4

Use the plate terminal packaged with the module. The size of the plate terminal is 1.0 mm wide with a thickness of 0.8 mm. More Details >>

Terminating resistors for QJ71C24N

A terminating resistor must be connected to the interface in order to reduce signal reflections thus preventing the signal instabilities. More Details >>

Terminating resistors for RS-422 communication of QJ71C24N

The resistance value is 330 ohm, 1/4 W. More Details >>

Displaying devices in GX Works2

Yes. The device use list also displays the devices used for specifying digits, such as "K4M0" (including M1, M2, or others). More Details >>

How to check errors with error codes of QD75

Errors can be checked with the following error detection signals and buffer memory areas corresponding to each axis.- Axis 1 Error detection X8 Buffer memor... More Details >>