Settings required for transient transmission

The routing parameter settings are required for transient transmission to the CPU module with another network No. The request source station, relay station,... More Details >>

How to make the expanded cyclic setting for CC-Link local stations

Make the expanded cyclic setting for a CC-Link local station using the programming tool, GX Developer or GX Works2. Follow the procedure below. (1) Set th... More Details >>

Duplication error in a CC-Link master station

Possible causes are as follows.(1) Another master station exists on the same line.(2) Noise is detected on the line at power on. More Details >>

Using special blocks (extension blocks) away from a main unit

To use the special blocks away from the main unit, connect them with the FX0N-30EC/FX0N-65EC extension cable and the FX2N-CNV-BC connector conversion adapter. More Details >>

Regarding maximum number of connected stations for built-in CC-Link IE TSN

The maximum number of stations that can be connected in the network depends on the model name of the MX-F model. ・MXF100-16 N32/P32: Up to 46 stations ・MXF... More Details >>

Regarding maintaining device back up

Battery: FX3U-32BL is not required for device back up.The battery is used to store clock data. More Details >>

Local devices

Local devices are devices which can be independently used for each program.When multiple independent programs are executed, using local devices allows progra... More Details >>

Reading file registers simultaneously with the program, parameters, and other data in GX Works2

No. Switch the target memory for PLC Data and read the file registers alone. More Details >>

Communication between the Ethernet port on the universal model QCPU and the built-in Ethernet port on the LCPU

The communication can be established using the following methods. - Using the socket communication function of both CPU modules - Using the simple PLC comm... More Details >>

Change timing of the status of A/D conversion module's I/O signals

(1)If the A/D conversion enable signal is kept ON, conversion processing is kept performed. Once conversion processing is successfully performed, A/D conve... More Details >>