Accessing an A series Ethernet interface module via a router using GX Developer

For GX Developer, a connection via an A series Ethernet interface module allows communication only within the same segment. Via a router, it is impossible to... More Details >>

Reading a project in another format

To open a project created with GX Developer, select [Project]-> [Import file]-> [Import from xxxx format file] from the menu in GX Works2. More Details >>

Precautions taken when QJ61BT11 is replaced with QJ61BT11N

Set the Network Parameter as shown below. (1) If QJ61BT11 is in the remote net mode, use the remote net Ver.1 mode for QJ61BT11N. (2) If QJ61BT11 is in the... More Details >>

Effect on sequence scans in MELSECNET/H networks

It is necessary to reduce the link refresh time of the MELSECNET/H network in order to reduce the scan time. The link refresh time can be reduced by reducin... More Details >>

Links with a CC-Link local station cannot be made

Check the following points. (1) CC-Link cables have been properly connected. (2) Station numbers and the transmission speed have been correctly set. (3)... More Details >>

Precaution about MELSECNET/H connection (1)

- Set successive station numbers for the network modules in system A and system B in a redundant system. (Station number 0 cannot be set.) - Match "host... More Details >>

E-mail sending/receiving function of the FX3U-ENET-L

E-mail sending function is supported, but receiving function is not available. More Details >>

Number of GOTs (GOT1000 series) that can be connected to a FX3U-ENET-L

Up to two GOTs can be connected toa FX3U-ENET-L and MELSOFT connection needs to be set. More Details >>

Setting for installing a memory cassette

When the programmable controller is powered on after a memory cassette is installed, the memory cassette is automatically recognized. After the memory casset... More Details >>

Connecting special adapters to the FX3G series

An FX3G-CNV-ADP is required. More Details >>