Memory allocation for online change in GX Developer

Select [Online] -> [Write to PLC] on the menu of GX Developer, open the [File selection] tab, and press "Param + Prog" button. Then open the [Program] ta... More Details >>

Transparent function

Set as follows in the Transfer Setup window. - Select "USB" for "PC side I/F". - Select "GOT" for "PLC side I/F" and select "via GOT (direct coupled) tra... More Details >>

GX Works2's compatibility with Monitor (write mode)

From version 1.62Q, GX Works2 supports Monitor (write mode). Pressing Shift+F4 allows an online change. More Details >>

How to set a value in SM414(2n second clock)

Set a value in the special register SD414.Use a MOV instruction to set the value in SD414. More Details >>

GX Configurator-MB for the MODBUS(R) interface module

GX Configurator-MB does not need to be purchased. Parameters can be set using GX Works2 alone. More Details >>

Alive check for built-in Ethernet port LCPU

When the protocol is set to TCP, KeepAlive check is performed. (Checking for a response to KeepAlive ACK message) An alive check message is sent five seconds... More Details >>

I cannot convert a circuit created with GX Developer.

When the conversion is executed, online change is automatically executed.When the online change at the upper right section of the setting in "Options" of "To... More Details >>

Cause to turn on the ERR LED of a CC-Link master module

All stations communication error of a slave station.When POWER of the slave station is off, check if 24 V DC has been supplied.When POWER is on, check the st... More Details >>

Differences between CC-Link IE Control Network and CC-Link IE Field Network

The CC-Link IE Control Network is a high-capacity controller network whose maximum number of link points is 128k words. The CC-Link IE Field Network is an al... More Details >>

Support of the DHCP (Dynamic Host Configuration Protocol) function by the FX3U-ENET-L (for Ethernet communications)

The FX3U-ENET-L does not support the DHCP function. Set the fixed IP address using FX Configurator-EN-L. (FX Configurator-EN-L can be downloaded from Mitsubi... More Details >>