How to set CC-Link reserved stations

- If the Network Parameter is used Make "Station Information Setting". - If the parameter is set using a dedicated instruction Set the control data of... More Details >>

CC-Link master modules' start I/O No. and refresh devices RX/RY

The I/O numbers used for I/O modules and intelligent function modules cannot be used as refresh targets for RX/RY. Use the I/O numbers greater than those use... More Details >>

Transient transmission of the CC-Link IE Controller

Transient transmission is a function that allows communication with programmable controllers in other stations. Communication with programmable controllers i... More Details >>

Setting required to skip CC-Link slave station numbers

A CC-Link slave station number can be skipped by assigning the skipped number to a reserved station. A reserved station is counted as one of all the connecte... More Details >>

Unit of the receive data length used by the QJ71C24N series pre-defined protocol support function

The receive data length of the variable is specified in bytes. More Details >>

Model name of the connector used for the FCN connector type CC-Link remote I/O module

FCN connectors (40-pin connector) are shown below.- A6CON1 (soldering connector)- A6CON2 (crimp connector)- A6CON3 (pressure-displacement connector)- A6CON4 ... More Details >>

Link data from communication error stations in a CC-Link network

The remote input RX of the master station and the remote input RX and remote output RY of local stations clear/hold the data from an error station according ... More Details >>

Parameter setting of CC-Link IE Field Network

No, you do not have to set the network range assignment parameters for slave stations. By setting the network range assignment parameters for a master statio... More Details >>

Relation between CC-Link terminals and signal lines

The following shows the relations between CC-Link terminals and signal lines. - DA : Blue -DB: White -DG: Yellow More Details >>

FL-net setting of GX Works2

You can set the parameters of the FL-net interface module with the data operation of the intelligent function module. For details and operation procedure of... More Details >>