About network parameters when building MELSECNET/10 with Q02HCPU-A

Q02(H)CPU-A is the AnUCPU equivalent. When establishing a MELSECNET/10 network, set the refresh parameter with which SB/SW data is transferred to "Y/D" or o... More Details >>

Terminating resistors for RS-485 communication of LJ71C24

The resistance value is 110 ohm, 1/2 W. More Details >>

Terminating resistors for QJ71C24N

A terminating resistor must be connected to the interface in order to reduce signal reflections thus preventing the signal instabilities. More Details >>

Can I open a program created with GX Works2 in GX Developer?

You cannot open a program in the file format for GX Works2. When saving a project with GX Works2, save it in the format for GX Developer.(This is possible on... More Details >>

GX Developer's compatibility with LJ71E71-100

GX Developer does not support LJ71E71-100. Use GX Works2. More Details >>

GX Developer's compatibility with QnUDVCPU

GX Developer does not support QnUDVCPU. Please use GX Works2 instead. More Details >>

A message that says "A T/C coil with the same No. exists."

It is a confirmation message telling a user that there is a device, T or C, that has become a duplicated coil in the same program and the coil is given the s... More Details >>

LCPU protection function

A password can be set. - Use the file password 32 function.- Number of characters: 4 to 32 (alphanumeric and special characters, case-sensitive)- Disabled op... More Details >>

Difference between standard inputs A06 to B11 and high-speed inputs A12 to B20 of LCPU built-in I/O function

The minimum input response times are different. The minimum input response time is 100 microseconds for standard inputs, and 10 microseconds for high-speed i... More Details >>

How to use LCPU connector terminals

The LCPU connector terminals can be used as terminals for built-in I/O function. The setting of the built-in I/O function can be configured with the paramete... More Details >>