SD memory cards used for Q24DHCCPU-V

Mitsubishi Electric's SD memory cards, which can be installed into Q24DHCCPU-V, are shown below. - NZ1MEM-2GBSD (memory capacity: 2Gbytes) - NZ1MEM-4GBSD (... More Details >>

Number of tasks to be created

The number of tasks that can be created depends on free space of the work RAM. Execute the following command with shell to check the free space of the work R... More Details >>

Pulse width with which the QX42 recognizes all pulses

Maximum scan time (10 ms) + Response time (10 ms) = Pulse width with which the module recognizes all pulses (20 ms) More Details >>

How to use L series extension modules

The extension module is used to configure the extension block when 10 modules or more are mounted to LCPU. Connect the branch module and the extension module... More Details >>

Availability of step ladders for FX in L series

Step ladders are not available in LCPU. There is no alternative function. More Details >>

Use of a commercial SD memory card in L series logging function

Yes. Recommended products are listed in the technical bulletin FA-A-0078.　 More Details >>

Operation during power failure

It stops during execution. More Details >>

Execution of the SOCRMODE instruction in the same connection during socket communication of LCPU

It can be executed for the same connection number. When data exist in the socket communication receive data area and the SOCRMODE instruction is executed, va... More Details >>

Simultaneous broadcast reception setting for built-in Ethernet port LCPU

To receive simultaneous broadcast using UDP, set the parameters as follows. - Destination IP Address: FF.FF.FF.FFh - Destination Port No.: Other than FFFFh (... More Details >>

FNC connector pin layout in L series I/O module and Q series I/O module

Yes. They have the same pin layout. More Details >>