How to use LCPU connector terminals

The LCPU connector terminals can be used as terminals for built-in I/O function. The setting of the built-in I/O function can be configured with the paramete... More Details >>

Retention of auto tuning setting value for temperature control module

Use the automatic backup setting. While "1: enabled" is set in the CH[] automatic backup setting after auto tuning of PID constants in the buffer memory (Un\... More Details >>

Alive check for built-in Ethernet port LCPU

When the protocol is set to TCP, KeepAlive check is performed. (Checking for a response to KeepAlive ACK message) An alive check message is sent five seconds... More Details >>

Battery replacement for LCPU

The contents of the standard RAM and latch devices are not erased if the battery replacement is completed within three minutes, which is the backup power tim... More Details >>

Cross cable connections

We do not guarantee the operation of a system that involves cross cable connections. More Details >>

Simulation function not started

The simulation function utilizes the standard TCP/IP communication provided by Microsoft Corporation. A communication capability of software of another make... More Details >>

How to write to file registers in Q series

Specify the file in the Write to PLC window and execute writing. More Details >>

Software to be supplied with GX Works3

GX Works2 and GX Developer are supplied with GX Works3. When installing GX Works3, you can select whether to install GX Works2 and GX Developer together. More Details >>

Regarding program capacity

The program cache memory (capacity) of the MX-F model is 12 MB. ※12 MB is equivalent to over 200K steps. More Details >>

Regarding connectable Intelligent Function modules

The MX-F Model can be connected to the intelligent function modules of the iQ-F series. Connectable intelligent function modules are shown below. More Details >>