MELSOFT MT Works2

MELSOFT MT Works2 is engineering software for Motion controllers that provides comprehensive support - from system design, parameter settings, program creati... More Details >>

How to relay CC-Link cables

Use a T-branch repeater module instead of a terminal block. More Details >>

Differences between the AJ65SBTB1-16TE and AJ65SBTB1B-16TE1

The following shows the major differences. -AJ65SBTB1-16TE - 1-wire terminal block, 1-common type - Maximum load current: 0.1 A/point -Protection fu... More Details >>

Cause to turn on the ERR LED of a CC-Link master module

All stations communication error of a slave station.When POWER of the slave station is off, check if 24 V DC has been supplied.When POWER is on, check the st... More Details >>

Extending the station-to-station distance with a CC-Link IE controller

Use the optical media converter DMS-1000SL(-DC) (manufactured by Mitsubishi Electric System & Service Co., Ltd.). You can extend the station-to-station dista... More Details >>

CD terminal setting of the QJ71C24N

"The CD terminal is not checked" has been set by default. More Details >>

Data length for fixed buffer data communications by QJ71E71

The units of send data and receive data are shown below. - Fixed buffer data communications with the "Procedure Exist" control method: Words - Fixed buff... More Details >>

Mixing line topologies with star topologies in the CC-Link IE Field Network　

Line topologies and star topologies can be mixed. More Details >>

Refresh timing of bit data and word data in the same CC-Link station

Cyclic data is sometimes separated into new and old data by two words (32 bits) with auto refresh timing. Checking "Block data assurance per station" of the ... More Details >>

Precaution about MELSECNET/H connection (1)

- Set successive station numbers for the network modules in system A and system B in a redundant system. (Station number 0 cannot be set.) - Match "host... More Details >>