PLC write not possible due to memory overload

If comments cannot be stored in the program memory, write them in the standard ROM or a memory card. Calculate the memory capacity in GX Works2 or GX Develop... More Details >>

Storing the data logging setting to an SD memory card in LCPU

In the write logging setting, choose [Online] and [Write Logging Setting], and set the target memory to SD memory card. More Details >>

LCPU internal clock synchronization

Use the time setting function to synchronize the internal clock. More Details >>

How to use L series extension modules

The extension module is used to configure the extension block when 10 modules or more are mounted to LCPU. Connect the branch module and the extension module... More Details >>

Use of an A-compatible 1E frame for the built-in Ethernet port of LCPU

The built-in Ethernet port in the L series is compatible only with a QnA-compatible 3E frame of the MC protocol. An A-compatible 1E frame is not supported. More Details >>

Replacing an AnS I/O module with a Q I/O module

Yes. More Details >>

SD memory cards used for Q24DHCCPU-V

Mitsubishi Electric's SD memory cards, which can be installed into Q24DHCCPU-V, are shown below. - NZ1MEM-2GBSD (memory capacity: 2Gbytes) - NZ1MEM-4GBSD (... More Details >>

GX Configurator-MB for the MODBUS(R) interface module

GX Configurator-MB does not need to be purchased. Parameters can be set using GX Works2 alone. More Details >>

Input derating

Input derating is the percentage of simultaneous ON points, one of the specifications applied when input modules are used. When QX42 is used in a temperatur... More Details >>

Intelligent function module settings in GX Works2

Modules do not need setting in GX Works2 if not selectable from "Module Selection" in the "New Module" window for intelligent function module settings. More Details >>