Connecting QJ71C24N to an external device that has no DTR signal

Carry out DTR and DSR wiring that returns signals on QJ71C24N(-R2). More Details >>

CC-Link IE Controller cable standard

Use the cables that meet the IEC60793-2-10 Types A1a.1 optical fiber standard. The connectors are LC (duplex) connectors. Two cores are required.The core di... More Details >>

Transient transmission of the CC-Link IE Controller

Transient transmission is a function that allows communication with programmable controllers in other stations. Communication with programmable controllers i... More Details >>

Whether or not MC protocol frames can be used after A1SJ71UC24 is replaced with QJ71C24N

The QJ71C24N series modules can be accessed using A-compatible 1C frames, but the following restrictions are imposed. The access is limited to the devices wi... More Details >>

How refresh devices for CC-Link remote inputs and outputs are assigned

The refresh device setting of the CC-Link parameter assigns any devices to the I/O numbers greater than those assigned to the modules on the same base unit. ... More Details >>

Precautions taken when QJ61BT11 is replaced with QJ61BT11N

Set the Network Parameter as shown below. (1) If QJ61BT11 is in the remote net mode, use the remote net Ver.1 mode for QJ61BT11N. (2) If QJ61BT11 is in the... More Details >>

Creating function blocks

The number of FB definitions created in a project has no limitation. More Details >>

Number of connectable modules

Up to 10 modules are connectable. Note that RS-232 adapter and END cover are excluded. Use the built-in CC-Link function for I/O enhancement. More Details >>

KeepAlive setting for built-in Ethernet port in LCPU

The KeepAlive setting for the built-in Ethernet port in the L series is fixed. The setting is unchangeable. More Details >>

Storing the data logging setting to an SD memory card in LCPU

In the write logging setting, choose [Online] and [Write Logging Setting], and set the target memory to SD memory card. More Details >>