Regarding CAN Communication

The FX5 CPU module does not support CAN communication. More Details >>

Regarding the connection between FX5-CCLGN-MS and inverter

FX5-CCLGN-MS supports 1 Gbps communication speed with firmware version: 1.010, and 1 Gbps and 100 Mbps communication speed for version 1.010. If the communi... More Details >>

Output numbers of the FX programmable controllers

Since they are octal, the number after Y7 is Y10 and after Y77 is Y100. More Details >>

Support of the DHCP (Dynamic Host Configuration Protocol) function by the FX3U-ENET-L (for Ethernet communications)

The FX3U-ENET-L does not support the DHCP function. Set the fixed IP address using FX Configurator-EN-L. (FX Configurator-EN-L can be downloaded from Mitsubi... More Details >>

How to relay CC-Link cables

Use a T-branch repeater module instead of a terminal block. More Details >>

Using Ethernet UTP cables for the CC-Link IE Controller

Ethernet UTP cables cannot be used. More Details >>

Precaution about MELSECNET/H connection (1)

- Set successive station numbers for the network modules in system A and system B in a redundant system. (Station number 0 cannot be set.) - Match "host... More Details >>

Connecting terminating resistors for CC-Link communication

Connect terminating resistors to both ends of physical cables.A master station is not necessarily required to be connected to either end of its network. More Details >>

Receiving data when no receive complete code is designated (QJ71C24N)

Data are received on a received data count basis. If there is no receive complete code and variable length data is received, the data is received at every no... More Details >>

CC-Link IE Controller cable standard

Use the cables that meet the IEC60793-2-10 Types A1a.1 optical fiber standard. The connectors are LC (duplex) connectors. Two cores are required.The core di... More Details >>