Terminating resistors for RS-485 comm...
The resistance value is 110 ohm, 1/2 W. More Details >>
QJ71E71-100's compatibility with the ...
QJ71E71-100 does not support the AutoMDI/MDI-X function (automatic cable type (straight or cross) recognizing feature). More Details >>
Precautions taken when QJ61BT11 is re...
Set the Network Parameter as shown below. (1) If QJ61BT11 is in the remote net mode, use the remote net Ver.1 mode for QJ61BT11N. (2) If QJ61BT11 is in the... More Details >>
Necessity of terminating resistors in...
No, it is unnecessary. Terminating resistors are only required at both ends of the network. More Details >>
You can set the parameters of the FL-net interface module with the data operation of the intelligent function module. For details and operation procedure of... More Details >>
Differences between the AJ65SBTB1-16T...
The following shows the major differences. -AJ65SBTB1-16TE - 1-wire terminal block, 1-common type - Maximum load current: 0.1 A/point -Protection fu... More Details >>
Assignment for connecting two CC-Link...
X devices will be assigned as follows. (With this setting, 32 points are occupied per station.) - Station No. 1: X100 to X11F -Station No. 2: X120 to X13... More Details >>
SB/SW refresh device setting with CC-...
There are no problems even though the SB/SW refresh device has not been set. More Details >>
Extending the station-to-station dist...
Use the optical media converter DMS-1000SL(-DC) (manufactured by Mitsubishi Electric System & Service Co., Ltd.). You can extend the station-to-station dista... More Details >>
Limitation on the number of MELSOFT p...
In the TCP/IP connection, you can connect up to 17 MELSOFT products at the same time using a dedicated connection for system and the connections for users 1 ... More Details >>
71-80 of Total 110