KeepAlive setting for built-in Ethernet port in LCPU

The KeepAlive setting for the built-in Ethernet port in the L series is fixed. The setting is unchangeable. More Details >>

How to check errors with error codes of QD75

Errors can be checked with the following error detection signals and buffer memory areas corresponding to each axis.- Axis 1 Error detection X8 Buffer memor... More Details >>

Specifying steps in printing data displayed in the window in GX Works2

GX Works2 Version 1.45X or later supports a print range specifying capability.Set "Start Step" and "End Step" for "Specified Print Range" in the Print window. More Details >>

Replacing an AnS I/O module with a Q I/O module

Yes. More Details >>

High-speed timer

Follow the procedure below to insert a high-speed timer.- Click the Coil button on the toolbar or press the function key F7, then enter "HT[ ] K[ ]".- Click ... More Details >>

Transparent function

Set as follows in the Transfer Setup window. - Select "USB" for "PC side I/F". - Select "GOT" for "PLC side I/F" and select "via GOT (direct coupled) tra... More Details >>

Using GX Logviewer's realtime monitor function on multiple personal computers

Up to two realtime monitor windows can be used for monitoring.If each of two personal computers monitors one monitor window, two personal computers can be co... More Details >>

Support of the DHCP (Dynamic Host Configuration Protocol) function by the FX3U-ENET-ADP (for Ethernet communications)

The FX3U-ENET-ADP does not support the DHCP function. Set the fixed IP address using the parameter setting of GX Works2. On GX Works2, select "Parameter" and... More Details >>

Links with a CC-Link local station cannot be made

Check the following points. (1) CC-Link cables have been properly connected. (2) Station numbers and the transmission speed have been correctly set. (3)... More Details >>

Regarding firmware updates for newly purchased CPU modules

You can still update the firmware. More Details >>