GX Developer installation procedure from the iQ Works disk

Use setup.exe in the [GXD1] folder of the installation disk to install the application. More Details >>

Battery life

It depends on the model of the CPU module, the amount of battery consumption, and the power-on time ratio.Example) For Q06HCPU with power-on time ratio of 50... More Details >>

Built-in Ethernet function setting window of MELSEC iQ-R series CPU modules

"Module Parameter" of the CPU module is the setting window. <Setting a built-in Ethernet port> [Navigation Window]-> [Parameter]-> [CPU Modul... More Details >>

I cannot place a main base unit in a module configuration diagram with GX Works3.

You may have already placed a main base unit in the module configuration diagram. Scroll up or down in the module configuration diagram and check if a main ... More Details >>

I/O numbers of a MELSEC iQ-R series I/O combined module (RH42C4NT2P)

An input and output use a single I/O number. (This is the same as QH42P.) When you replace a module that uses serial I/O numbers (e.g. QX41Y41P) with this m... More Details >>

Regarding FX5-ENET, FX5-ENET/IP IP addresses

You cannot configure two IP addresses. More Details >>

Regarding "_ U" in Application Instruction

It means an instruction that handles BIN 16 bit and BIN 32 bit unsigned data. Example:ADD _ U More Details >>

Maximum length of input wiring

Although it depends on the operating environment, wiring within 20 m is generally recommended. More Details >>

Differences between the AJ65SBTB1-16TE and AJ65SBTB1B-16TE1

The following shows the major differences. -AJ65SBTB1-16TE - 1-wire terminal block, 1-common type - Maximum load current: 0.1 A/point -Protection fu... More Details >>

SB/SW refresh device setting with CC-Link

There are no problems even though the SB/SW refresh device has not been set. More Details >>