Necessity of terminating resistors in CC-Link communication

No, it is unnecessary. Terminating resistors are only required at both ends of the network. More Details >>

Difference in specifications between "AJ65BT" and "AJ65SBT" in CC-Link remote I/O modules' model names

"[ ]" in the CC-Link remote I/O modules' model name "AJ65[ ]BT" represents as follows: - None: Standard type - S: Compact type - F: Low profile waterpro... More Details >>

Settings required for transient transmission

The routing parameter settings are required for transient transmission to the CPU module with another network No. The request source station, relay station,... More Details >>

Using a FROM/TO instruction after AJ71UC24 is replaced with QJ71C24N

I/O signals and buffer memory addresses need to be changed but data communications can be conducted using a FROM/TO instruction and X/Y signals. More Details >>

Effect on sequence scans in MELSECNET/H networks

It is necessary to reduce the link refresh time of the MELSECNET/H network in order to reduce the scan time. The link refresh time can be reduced by reducin... More Details >>

Cables for CC-Link networks

Use CC-Link dedicated cables. General-purpose cables cannot be used. More Details >>

RS-485 connection between LJ71C24 and an external device

Short between SDA and RDA and between SDB and RDB, and then connect them to + (Data-A) and - (Data-B) on the external device. More Details >>

Unit of receive data used by the QJ71C24N series pre-defined protocol support function

The fixed data is used for specific codes and character strings such as a command. Setting a device is not required. More Details >>

Link data from communication error stations in a CC-Link network

The remote input RX of the master station and the remote input RX and remote output RY of local stations clear/hold the data from an error station according ... More Details >>

Refresh timing of bit data and word data in the same CC-Link station

Cyclic data is sometimes separated into new and old data by two words (32 bits) with auto refresh timing. Checking "Block data assurance per station" of the ... More Details >>