Specifying steps in printing data displayed in the window in GX Works2

GX Works2 Version 1.45X or later supports a print range specifying capability.Set "Start Step" and "End Step" for "Specified Print Range" in the Print window. More Details >>

MX Component's compatibility with Windows7 Embedded

MX Component does not support Windows7 Embedded. More Details >>

Data communications between programmable controllers

Any data can be sent and received if the socket communication function instructions are used. More Details >>

How to specify intelligent function module devices

For "U**", set the first two digits of the start I/O number of an intelligent function module in three-digit representation.Example) For X/Y1F0, set "U1F". More Details >>

Replacing personal computers with C Controller modules

The merits are as follows. (1) Downsized device The volume ratio is 1 to 10 in comparison with the VME card rack (6U) type. (2) Long-term stable supply... More Details >>

SD memory cards used for Q24DHCCPU-V

Mitsubishi Electric's SD memory cards, which can be installed into Q24DHCCPU-V, are shown below. - NZ1MEM-2GBSD (memory capacity: 2Gbytes) - NZ1MEM-4GBSD (... More Details >>

Replacing an AnS I/O module with a Q I/O module

Yes. More Details >>

Ethernet system configuration of a redundant system

The following figure shows the basic configuration. When a control system Ethernet module is faulty or disconnected, the system is switched at a disco... More Details >>

Pulse width with which the QX42 recognizes all pulses

Maximum scan time (10 ms) + Response time (10 ms) = Pulse width with which the module recognizes all pulses (20 ms) More Details >>

Availability of step ladders for FX in L series

Step ladders are not available in LCPU. There is no alternative function. More Details >>