MX Component Version 4's compatibility with 64-bit Windows 7

Yes. More Details >>

Reading project data from a CD-R

To reopen project data written to a CD-R, copy the project data into a space such as a hard disk on the personal computer where the project data is used.This... More Details >>

How to set CC-Link reserved stations

- If the Network Parameter is used Make "Station Information Setting". - If the parameter is set using a dedicated instruction Set the control data of... More Details >>

CC-Link master modules' start I/O No. and refresh devices RX/RY

The I/O numbers used for I/O modules and intelligent function modules cannot be used as refresh targets for RX/RY. Use the I/O numbers greater than those use... More Details >>

Setting required to skip CC-Link slave station numbers

A CC-Link slave station number can be skipped by assigning the skipped number to a reserved station. A reserved station is counted as one of all the connecte... More Details >>

CC-Link IE Controller cable standard

Use the cables that meet the IEC60793-2-10 Types A1a.1 optical fiber standard. The connectors are LC (duplex) connectors. Two cores are required.The core di... More Details >>

1 ms timer (FX3G/3GC series)

Yes, there is. T256 to T319 can be used for the1 ms timer, and T246 to T249 can be used for the 1 ms retentive timer. More Details >>

How to use built-in high-speed counters

For contacts to drive the coils of high-speed counters, use the contacts which are normally on during high-speed counting. Do not use the input (X000 to X00... More Details >>

Connecting the FX3U-ENET-L whose parameters have not been set

When writing parameters first time, write the parameters for Ethernet (data of FX Configurator-RN-L) from a personal computer to a programmable controller ma... More Details >>

Measurement of the counter in the MC (master control) circuit

When the count condition of the counter in the MC circuit remains set, the counter counts when the MC circuit is turned on. More Details >>