GX Configurator-MB for the MODBUS(R) interface module

GX Configurator-MB does not need to be purchased. Parameters can be set using GX Works2 alone. More Details >>

Communication between Ethernet and FL-net

The communication between the Ethernet interface module and FL-net (OPCN-2) interface module cannot be established. More Details >>

How to display local comments in GX Works2

In the "Reference/Reflection Target for Device Comment" window, switch the "Specify the Reference/Reflection" from "Global" to "Local". More Details >>

Returning to the overwrite mode in GX Developer

Press the INSERT key. More Details >>

Compatibility with 64-bit Windows 7

GX Works2 Version 1.62Q or later supports Windows 7. More Details >>

Heat generation of Q61P power supply module

Since the conversion efficiency of the power supply module is approximately 70%, and 30% of the output power is dissipated as heat, the power consumption is ... More Details >>

GX Works2 installation procedure from the iQ Works disk

Use setup.exe in iQ Works Disk 2 (appears directly under the disk folder), to install the application.For the individual installation procedure from the iQ W... More Details >>

Difference between GX Works2 and GX Works

GX Works2 is programmable controller engineering software integrating programming and simulation of programmable controller and setting monitor tool functio... More Details >>

Using a commercially-available SD memory card for a MELSEC iQ-R series CPU module

For the commercially-available SD memory cards that can be used for MELSEC iQ-R series CPU modules, refer to the following technical bulletin. - TECHNICAL ... More Details >>

Regarding communication supported by built-in RS-485 port

N:N Network, Parallel Link, MC protocol, Non-protocol communication, MELSOFT connection, MODBUS RTU, and Predefined protocol support are available. More Details >>