Regarding Project verification

You can verify from GX Works3 Project - Verify with PLC. Manual GX Works3 Operating Manual More Details >>

Regarding the FX5S CPU Module Line-up

The line-up of input and output points of the FX5S CPU module is as follows. ・30 points (Input: 16 points, Output: 14 points) ・40 points (Input: 24 points,... More Details >>

AC input type main unit in the FX3 series

FX3U-32MR/UA1 and FX3U-64MR/UA1 are AC input types. More Details >>

Power supply of the FX3U-ENET-ADP Ethernet communication special adapter

No, it is not necessary because power is supplied internally from the main unit. More Details >>

Support of the DHCP (Dynamic Host Configuration Protocol) function by the FX3U-ENET-L (for Ethernet communications)

The FX3U-ENET-L does not support the DHCP function. Set the fixed IP address using FX Configurator-EN-L. (FX Configurator-EN-L can be downloaded from Mitsubi... More Details >>

Refresh timing of bit data and word data in the same CC-Link station

Cyclic data is sometimes separated into new and old data by two words (32 bits) with auto refresh timing. Checking "Block data assurance per station" of the ... More Details >>

Precaution about MELSECNET/H connection (1)

- Set successive station numbers for the network modules in system A and system B in a redundant system. (Station number 0 cannot be set.) - Match "host... More Details >>

Overall cable distance and station-to-station distance in CC-Link networks

The overall cable distance and station-to-station distance depend on the version and the transmission speed. Figure 1 shows the case with Ver.1.10-compatibl... More Details >>

Cables for CC-Link networks

Use CC-Link dedicated cables. General-purpose cables cannot be used. More Details >>

Transient transmission of the CC-Link IE Controller

Transient transmission is a function that allows communication with programmable controllers in other stations. Communication with programmable controllers i... More Details >>