Replacing personal computers with C Controller modules

The merits are as follows. (1) Downsized device The volume ratio is 1 to 10 in comparison with the VME card rack (6U) type. (2) Long-term stable supply... More Details >>

SD memory cards used for Q24DHCCPU-V

Mitsubishi Electric's SD memory cards, which can be installed into Q24DHCCPU-V, are shown below. - NZ1MEM-2GBSD (memory capacity: 2Gbytes) - NZ1MEM-4GBSD (... More Details >>

Ethernet system configuration of a redundant system

The following figure shows the basic configuration. When a control system Ethernet module is faulty or disconnected, the system is switched at a disco... More Details >>

Turning OFF the power with the battery error occurring

The error history will be deleted. More Details >>

Update timing of LD75 current feed value and machine feed value

The values are updated at the timing described below. - Current feed value: 0.9 ms - Machine feed value: 0.9 ms More Details >>

Availability of step ladders for FX in L series

Step ladders are not available in LCPU. There is no alternative function. More Details >>

Open setting of LCPU

No. It is necessary to configure one port to use the MELSOFT connection. More Details >>

Simultaneous broadcast transmission setting for built-in Ethernet port LCPU

To send simultaneous broadcast using UDP, set the parameters as follows.- Destination IP Address: FF.FF.FF.FFh - Destination Port Number: Other than FFFFh (S... More Details >>

Number of records in LCPU logging function

It is the number of data collected before and after a trigger occurrence. More Details >>

Retention of auto tuning setting value for temperature control module

Use the automatic backup setting. While "1: enabled" is set in the CH[] automatic backup setting after auto tuning of PID constants in the buffer memory (Un\... More Details >>