Unit of receive data used by the QJ71C24N series pre-defined protocol support function

The fixed data is used for specific codes and character strings such as a command. Setting a device is not required. More Details >>

Continuous executions of protocols by the QJ71C24N series CPRTCL instruction

One CPRTCL instruction can execute a maximum of eight protocols. More Details >>

32-bit data assurance

To assure 32-bit data, "Network Range Assignment" of the control station must satisfy the following conditions.(1) The start device No. of LB is a multiple o... More Details >>

Data length for fixed buffer data communications by QJ71E71

The units of send data and receive data are shown below. - Fixed buffer data communications with the "Procedure Exist" control method: Words - Fixed buff... More Details >>

Using Ethernet UTP cables for the CC-Link IE Controller

Ethernet UTP cables cannot be used. More Details >>

Relation between CC-Link terminals and signal lines

The following shows the relations between CC-Link terminals and signal lines. - DA : Blue -DB: White -DG: Yellow More Details >>

SB/SW refresh device setting with CC-Link

There are no problems even though the SB/SW refresh device has not been set. More Details >>

FL-net setting of GX Works2

You can set the parameters of the FL-net interface module with the data operation of the intelligent function module. For details and operation procedure of... More Details >>

Support of the DHCP (Dynamic Host Configuration Protocol) function by the FX3U-ENET-L (for Ethernet communications)

The FX3U-ENET-L does not support the DHCP function. Set the fixed IP address using FX Configurator-EN-L. (FX Configurator-EN-L can be downloaded from Mitsubi... More Details >>

Overwriting a current value with the high-speed counter comparison instruction

The output contact is activated according to the change of the current value register along with the counting input. Therefore, the value changed by executin... More Details >>