Terminating resistors for RS-485 communication of LJ71C24

The resistance value is 110 ohm, 1/2 W. More Details >>

Necessities for the execution environment of MX Component

Both the developed software and MX Component must be installed. More Details >>

How to use the "S/S" terminal

The "S/S" terminal is used to switch the input type (sink input and source input). For the source input, connect the "S/S" terminal to the "0V" terminal, a... More Details >>

Regarding the simultaneous use of Simple CPU Communication and FX5-CCLGN-MS MELSOFT Connection

Can be used simultaneously. More Details >>

Adding two channels of the RS-232C port in the FX3G series

Select the 40-point or 60-point type FX3G series main unit. In this case, two FX3G-232-BDs can be connected. When FX3G-CNV-ADP is used, anFX3U-232ADP can be ... More Details >>

Assignment for connecting two CC-Link remote input modules (16-point type) (Remote net Ver.1 mode)

X devices will be assigned as follows. (With this setting, 32 points are occupied per station.) - Station No. 1: X100 to X11F -Station No. 2: X120 to X13... More Details >>

Using Ethernet UTP cables for the CC-Link IE Controller

Ethernet UTP cables cannot be used. More Details >>

Precaution about MELSECNET/H connection (2)

- Set the network module mounted in system A to station number 0 (multiplexed remote master station). Set the network module mounted in system B to any sta... More Details >>

Latched (battery backed) area in the data register (D) of the FX3G/FX3GC series

D128 to D1099 are the latched device area. D1100 to D7999 can be changed to latched (battery backed) type devices by installing an optional battery and setti... More Details >>

Cause to turn on the ERR LED of a CC-Link master module

All stations communication error of a slave station.When POWER of the slave station is off, check if 24 V DC has been supplied.When POWER is on, check the st... More Details >>