Connection of FX-20P and FX3U series

Whenan entry code (2nd entry code) registration is set in the FX3U series, sucherror canoccur. More Details >>

Output frequency of the FX3U-1PG pulse output block

It is from 1 Hz to 200 kHz. More Details >>

Analog output modules that can be used in the FX3G series

The FX3G-1DA-BD (1-channel analog output extension board), FX3U-4DA-ADP (4-channel analog output special adapter), and FX3U-3A-ADP (2-channel analog input/1-... More Details >>

Output numbers of the FX programmable controllers

Since they are octal, the number after Y7 is Y10 and after Y77 is Y100. More Details >>

Extending the extension cable

It is not possible to extend the length of the extension cable to over 65cm. Place the main unit separately by using the parallel link or N:N Network functio... More Details >>

Drive products (servo amplifiers) that can be connected to the FX3U-1PG pulse output block

Servo amplifiers, such as MR-J4-□A and MR-JN-□A, that support pulse train input can be connected. For connectable drive products, such as servo amplifiers, ... More Details >>

Continuous executions of protocols by the QJ71C24N series CPRTCL instruction

One CPRTCL instruction can execute a maximum of eight protocols. More Details >>

Connecting AJ65BT-R2N to a GOT

Yes.When connecting a GOT, set the mode setting switch of AJ65BT-R2N to "5" (MELSOFT connection mode). More Details >>

Assigning X and Y signals of AJ65SBTB1-32DT

X and Y assignments are as follows.- X0 to XF- Y10 to Y1F More Details >>

Settings required for transient transmission

The routing parameter settings are required for transient transmission to the CPU module with another network No. The request source station, relay station,... More Details >>