FAQ


FAQAbout Products

FAQ
Keyword Search
Controllers
FAQ within [ Controllers ]
-
How to read device data and file registers in Q series
Specify the target memory in the Read from PLC window and execute reading. More Details >>
- No:22564
- Release Date:2018/09/03 17:29
- Category: MELSEC-Q Series
-
Acceleration/deceleration time change
No, the time cannot be changed during operation. (Note): The following is the modules that support the acceleration/deceleration change function. • Q17nDSCP... More Details >>
-
Regarding List Display/Edit Circuit Blocks
FX5 CPU module(GX Works 3) is not supported. More Details >>
- No:39291
- Release Date:2023/02/15 13:07
- Category: MELSEC iQ-F Series , CPU Module , Engineering Software
-
Regarding connection of SD Memory Card module: FX5-SDCD
It can be added in conjunction with an expansion board. For details on how to connect, refer to the following manual. MELSEC iQ-F FX5S/FX5UJ/FX5U/FX5UC Use... More Details >>
- No:39337
- Release Date:2023/02/14 17:27
- Category: MELSEC iQ-F Series , Option , CPU Module
-
Regarding CC-Link IE Filed Basic Protocol Mixing
It is possible to mix CC-Link IE Filed Basic and general-purpose Ethernet communication. More Details >>
- No:40031
- Release Date:2023/08/24 14:40
- Category: MELSEC iQ-F Series , CPU Module , Network/Communication
-
For the sink input, the "S/S" terminal and the "24V" terminal are needed to be short-circuited. More Details >>
- No:22263
- Release Date:2018/08/30 13:48
- Category: MELSEC-F Series , Main Unit , I/O Extension
-
Memory allocation for online change in GX Developer
Select [Online] -> [Write to PLC] on the menu of GX Developer, open the [File selection] tab, and press "Param + Prog" button. Then open the [Program] ta... More Details >>
- No:22547
- Release Date:2018/09/03 17:28
- Update:2018/09/20 15:09
- Category: MELSEC-Q Series
-
The Transfer Setup window is displayed in the Navigation window. More Details >>
- No:22579
- Release Date:2018/09/03 17:29
- Category: MELSEC-Q Series
-
SD1286 of LCPU with built-in Ethernet port
The bits 0 to F of the special register SD1286 (Receive state signal) correspond to the connection numbers 1 to 16. When it receives data, the corresponding ... More Details >>
- No:22786
- Release Date:2018/09/03 17:30
- Category: MELSEC-L Series
-
SB/SW refresh device setting with CC-Link
There are no problems even though the SB/SW refresh device has not been set. More Details >>
- No:23080
- Release Date:2018/09/03 17:31
- Category: Network related products
861-870 of Total 1110