Vector inverter option

Just by adding this option, encoder pulses connected to the inverter or option are output.You can also divide the pulse train output. More Details >>

Two-rank up maximum short-time torque

It is not possible to generate torque larger than the maximum possible torque of the motor by increasing the inverter's capacity.Even when the inverter is up... More Details >>

Installation of FR-BLF

The following benefits are provided when the FR-BLF is installed on the input side or output side.Choose the side to install the FR-BLF considering these ben... More Details >>

Relationship between frequency and output torque

The output torque characteristics of the FREQROL-E500 series are shown in the figure below. Figure 1 More Details >>

Operation at base frequency or higher

The output frequency is 55 Hz. (For V/F control)When the base frequency is set to 50 Hz, frequencies over 50 Hz is the constant output range.Note that the ma... More Details >>

CC-Link, analog output card

You can install only one option card.If you want to use two types of cards, replace the inverter with the FR-A700 series.If you can use RS485 communication i... More Details >>

FR-E700

Install the DIN rail attachment to each inverter.The optional FR-A7NC is built in the inverter and does not influence installation of the inverter. More Details >>

Terminal assignment

The terminal MRS assignment parameter is Pr.183. Set Pr.183 to "4" (AU). (This setting is for the E700.) More Details >>

FR-PA07

Yes. Use FR-CB20□. More Details >>

Model configuration

The following seven models are available for the 200 V class: 0.1K, 0.2K, 0.4K, 0.75K, 1.5K, 2.2K, and 3.7K The following five models are available for the 4... More Details >>