I want to drive other manufacturer's motor with PG

You can drive the motor with the FR-V240E-5.5K. However, the following conditions apply: - You need to perform auto tuning because the motor's circuit consta... More Details >>

Auxiliary input power supply

If you connect two frequency setting potentiometers to the terminals 5 and 10, the permissible current of 10 mA is exceeded, and you need to install 2 KΩ res... More Details >>

Speed setting

The high speed command (multi-speed command) is prioritized over the frequency setting potentiometer. It is OK if these are both input simultaneously. When t... More Details >>

IPM motor drive

Overshooting of the speed due to the acceleration/deceleration may be the cause. Overshooting is more likely to occur when the load inertia is too high. As a... More Details >>

Fast-response current limit

It is not activated because the function itself is disabled. More Details >>

MM-FR-A800

If the command is 0.01 Hz or higher, the positioning control is performed. More Details >>

MM-EF/EFS

Since the standard bearing is adopted for the belt drive models, a creep may occur and the motor bracket may wear out. More Details >>

Seamless communication of FR Configurator SW3

The communication via the MELSECNET is not available. More Details >>

Permissible brake duty

When consuming the regenerative power with the brake resistor, the brake transistor is triggered at a certain voltage to make the brake resistor use the rege... More Details >>

Speed 2 operation with potentiometer on operation panel

Yes. Set parameters as below.For FR-E500Set Pr.79 =3, and Pr.146= 0.Multi-speed is prioritized.For FR-S500Set Pr.79 = 3, and Pr.53 = 1.Multi-speed is priorit... More Details >>