FR-Configurator

No. You cannot connect it to multiple inverters.You can only connect a single personal computer to a single inverter via USB. More Details >>

FR-E700

Install the DIN rail attachment to each inverter.The optional FR-A7NC is built in the inverter and does not influence installation of the inverter. More Details >>

Surge voltage of 400 V inverter

1. Since the voltage resistance of the standard motor is not improved, it is recommended to use an "insulation-enhanced motor".If you are using an insulation... More Details >>

Inverter selection when driving multiple motors

When driving multiple motors with a single inverter, determine the inverter capacity in one of the following two methods:1. When driving multiple motors conn... More Details >>

Operation panel

Be sure to use the FR-E5P to mount the operation panel.This is because the board is bare on the back of the operation panel and a dedicated connector is requ... More Details >>

Using shielded wires for frequency meter connection

Connect the shield to the terminal SD. More Details >>

Fault contact when connecting separate power supply for each control circuit

Since the inverter's fault contact is an NC contact, it does not open unless a fault occurs.Therefore, when the control power supply (and main circuit power ... More Details >>

Inverter control power supply

To supply power via R1 and S1, 60 VA or higher is necessary for 22K or lower and 80 VA or higher is necessary for 30K to 55K.Note that the rush current of ap... More Details >>

All parameters returned to initial values

The parameters of the A500 series are stored in the EEPROM.The reason why all parameters returned to the initial values is considered that you may have opera... More Details >>

Endurance

The estimated lives of the parts of the FREQROL-E500 are as follows: Cooling fan at surrounding air temperature of 35 deg C???30,000 hrsPower supply smoothin... More Details >>