Wiring and terminal

The ferrule terminal or single wire can be used for the control circuit wiring. More Details >>

Wire length between inverter and motor

1. Wiring length between the inverter and the motor should be 500 m or less. For 0.75 kW or lower motors, the following relationship is true: Capacity... More Details >>

Encoder feedback speed accuracy

The speed variation rate is as follows: 　- Encoder feedback control: ±0.2% - Vector control: ±0.02% (mentioned in FR-A5AP Instruction Manual) More Details >>

Monitor output

The FM output is the 1440 Hz, 1 mA pulse train output at full scale. You can input to the programmable controller if it has a pulse train input. A68AD does n... More Details >>

Inverter input current

Since the input current has a distorted waveform and the waveform ratio is low, the total inverter input power factor is very poor depending on the power sup... More Details >>

Inverter with one-rank higher capacity

An inverter with one-rank higher capacity is often used when a high torque is required for a short period of time. (Examples)- When rapid acceleration/decele... More Details >>

Regenerative driving capability

Continuous 100% regenerative braking torque is available for the rated capacity of the high power factor converter. (The same braking ability of the FR-A201 ... More Details >>

Amount of heat generated

The following amount of heat is generated under the 100% load. (The same amount for both the 200 V and 400 V classes. The amount of heat generated by the bui... More Details >>

Size

The high power factor converter itself is almost same size as general-purpose inverter with the same capacity (FREQROL-A200 series), however, an additional s... More Details >>

DIN rail installation

You can do it by using the optional DIN rail attachment (FR-DU01/02). More Details >>