Difference in the monitor function

The same value is displayed in the initial setting. When negative output is enabled by setting "0" to Pr.290 (Monitor negative output selection), there are f... More Details >>

CAD data

They are not available. More Details >>

FR Configurator

Data with different capacity can be imported. Data with different voltage or model cannot be imported. More Details >>

Communication EEPROM write selection (Pr.342)

They are cleared by the RES signal from the external terminals or inverter reset from the communication. More Details >>

Speed command by CC-Link communication

It is not possible when the speed command is communication. More Details >>

FR-A5CN03

Since the heat sink and fan are not waterproof, you need to enclose them so that they are not exposed to the spray of water. If you use the inverter (heat si... More Details >>

Short-circuiting frequency setting terminals

You can short-circuit the terminals 10 and 2.If you are considering to perform operation at the maximum frequency, consider using the high-speed command RH o... More Details >>

FR-A800-GF

Yes, the options are the same as the FR-A800 standard model. Note that two options can be added at maximum. (One option is already used as standard.) Other c... More Details >>

EMC filter (SF1306)

There are two holes at the bottom of the EMC filter. The bigger hole at the lower part is for wire. Put the screwdriver into the small hole at the upper part... More Details >>

Wiring length

Under Real sensorless vector control, the maximum wiring length is 500 m. Under Vector control with encoder, the maximum wiring length is 100 m. More Details >>