FR-A800-R2R

If Pr.361 = 0, the second terminal can be used as the line speed command when X114 is ON, and as the frequency setting value when X114 is OFF. If Pr.361 = 3,... More Details >>

MM-CF

Yes. More Details >>

Inverter outline dimension CAD data

The outline dimension diagram is found on the member's page of Mitsubishi Electric FA Global Website.Contact our sales personnel for details on the programma... More Details >>

Reset selection

The specifications of the FR-V200E series do not allow for choosing from "Reset input always enabled" and "Reset input enabled only when the protective funct... More Details >>

When motor current is large

If the parameters related to the output voltage are not changed from the initial setting, it is unlikely that the output current at 55 Hz and 60 Hz is double... More Details >>

Current input switching operation

With your setting, since Pr.60 assigns the OH function to the terminal PL, and terminals RL and SD are open, an external protection error occurs. (It does no... More Details >>

Fault output terminal load pattern

The fault output terminals A and C, and B and C of the power regeneration converter FR-RC are not capable of a micro load of 5 VDC±5%, 10 mA. The minimum loa... More Details >>

400 Hz output setting

Change Pr.18 (High speed maximum frequency) to 400 Hz.If you are using the analog command to set the frequency, calibrate the 400 Hz frequency with Pr.903. More Details >>

Comparison with FR-A200E

In addition to speed control, you can also select torque control as well as you can perform position control using an option. The speed control range is as l... More Details >>

General-purpose magnetic flux control

Almost same control method. This control also performs vector calculation and divides the inverter's output current into an excitation current and into a tor... More Details >>