FR-A8NC

Two digits after the decimal point are rounded off. 28.139 Hz is rounded down to 28.13 Hz. More Details >>

Two-rank up maximum short-time torque

It is not possible to generate torque larger than the maximum possible torque of the motor by increasing the inverter's capacity.Even when the inverter is up... More Details >>

Frequency misalignment at current input

It seems that calibration of the current input is slightly incorrect.By using Pr.904 (Frequency setting current bias) and Pr.905 (Gain), you can calibrate th... More Details >>

Using built-in potentiometer and multi-speed together

Yes. Set Pr.79 = 3. (Input the start signal from an external source.) More Details >>

Intercompatibility attachment

Use the FR-AAT04 (FR-Z series intercompatibility attachment). More Details >>

Operation at base frequency or higher

The output frequency is 55 Hz. (For V/F control)When the base frequency is set to 50 Hz, frequencies over 50 Hz is the constant output range.Note that the ma... More Details >>

Advanced magnetic flux vector control

Yes. Set Pr.89 (Speed control gain) to "0". More Details >>

What functions are added by upgrading?

The following functions are added by upgrading: - Slip compensation function- Serial communication function- Frequency jump- 15-speed operation- Zero current... More Details >>

Are conventional parameter units still available?

The key sheet fixed to the inverter is used for operation. Therefore, the conventional parameter unit cannot be used. (There is no connector to connect it.)O... More Details >>

What are available inverters?

In addition to the FR-A200E series, you can use it with the following inverters: - FR-A024- FR-A200- FR-A100E- FR-A100- FR-V200- OthersAlso, supported by the... More Details >>