What are available inverters?

In addition to the FR-A200E series, you can use it with the following inverters: - FR-A024- FR-A200- FR-A100E- FR-A100- FR-V200- OthersAlso, supported by the... More Details >>

Parameters not covered in manual are displayed

Pr.168 indicates the inverter software version.Pr.169 indicates the inverter software subversion history. These two parameters are only used by the manufactu... More Details >>

Inverter current value

1. As the measurement condition is unknown, the possible cases are as follows: - If you measured the current on the input side of the inverter, since the cu... More Details >>

Load current limit of inverter

You can input current from the terminal AM of the inverter to the programmable controller (for A/D conversion) and control the speed with the software of the... More Details >>

Notes on using single-phase 200 V

With the single-phase 200 V input specifications, the input cable current increases. Therefore, choose larger power supply capacity and NF/MC than three-phas... More Details >>

Driving 200 V motor by 400 V inverter

Your suggested use is not recommended due to the following reasons: Output voltage of the 400 V inverter contains "micro surge". Usually this surge voltage i... More Details >>

Electronic bypass function

For countermeasures against the open/close surge of the MC (magnetic contactor). Insert a diode not to apply 27 VDC or more to the open collector terminal of... More Details >>

Brake sequence function

Turn OFF the BOF signal when switching the operation from forward rotation to reverse rotation. More Details >>

FR-A024

Pr.59 is available in the products manufactured in October 1995 or later. Therefore, it cannot be read from the products manufactured before October 1995. More Details >>

FR-FS

The acceleration time is 60 Hz and 5 seconds, and deceleration time is 60 Hz and 60 seconds. More Details >>