FR-A800-E

When it is required to keep the safety of the inverter and the system against unauthorized access from external devices via the network, take countermeasures... More Details >>

FR-A701

It is protected not by observing the temperature directly, but by estimating it from the current value, output frequency, and carrier frequency. More Details >>

FR-E700KNC

The inverter is reset. More Details >>

S-shape acceleration/deceleration of the FR-D700

It does not change even when General-purpose magnetic flux vector control is performed. Pr.3 is the inflection point of the S-shape. More Details >>

Connection point of the line noise filter

Connect the line noise filter between the inverter and EMC Directive compliant noise filter. More Details >>

Negative phase of input power supply

The power supplied to the inverter is converted into DC by the converter inside the inverter and then stored in the capacitor. Thus, reversing the phase sequ... More Details >>

Notes when inverter capacity is larger than motor capacity

When using one-rank-higher inverter, as you mention, you need to care about the setting of the electronic thermal O/L relay.Setting the electronic thermal O/... More Details >>

Using shielded wires for frequency meter connection

Connect the shield to the terminal SD. More Details >>

Alarm output signal when using CC-Link

The RX7 output signal is the same as the signals for NO, NC, and transfer contact output.You can change the contents of this output signal using Pr.192.Pr.19... More Details >>

Brake unit selection

Since the FR-A540-0.75K has a brake transistor for resistor regenerative driving inside the inverter, you do not need to use BU. Just remove the jumper from ... More Details >>